ALL
THERMOFORMED PACKAGING
TOOLING

 

 

 

part design

 

PART DESIGN

red dividing line

ODC is pleased to offer its Part Design service to the Thermoform Packaging Industry. Our design staff will consider all aspects of your unique packaging requirements and supply a solid model design that is timely, functional and attractive.

 

LEARN MORE

 

 

protyping packaging

 

PROTOTYPING

red dividing line

ODC offers complete prototyping services for the Thermoform Packaging Industry. From package design to prototype mold manufacturing, ODC will assist you in launching your new packages quickly and reliably.

 

LEARN MORE

 

 

production mold

 

PRODUCTION MOLDS

red dividing line

ODC is a recognized industry leader in the manufacture of production molds for the Roll Fed Thermoform Packaging Industry. From small bed cut-in-place molds for contact heat machines to large bed / plug assist third motion molds, ODC has the experience to handle your most demanding projects.

 

LEARN MORE

 

 

Matched Metal

 

MATCHED METAL TRIM TOOLS

red dividing line

ODC manufactures matched metal trim tools for in-chain and out-of-the chain trimming of thermoformed packages. You will find our staff knowledgeable in trimming the full range of thermoplastic films with the lowest possible generation of particulate. Clean trim is accomplished by consistently holding very small punch to die clearances (down to .0002"), maintaining exacting flatness and parallelism on all tooling components and using appropriate shear on the punches.

 

LEARN MORE

 

 

Sharp Edge trim

 

SHARP EDGE TRIM

red dividing line

Our craftsmen manufacture the highest quality hand forged and solid machined cutting dies available in the industry. Continuously produced by ODC since 1923, forged dies, also known as high dies, are the best solution for cut-in-place and high volume in-line cutting of thermoplastic sheet. Solid machined dies are used for pass through hanger cutouts, "Euro slots" and intricate trim line requirements.

 

LEARN MORE

 

 

two people sitting at a table looking over paperwork

 

PROCESS CONSULTATION
/ INSTALLATION SERVICES

red dividing line

ODC’s engineering staff is available for in-plant consultation to assist thermoformers on tooling issues ranging from thermoforming process improvements to trim press adjustments for flatness and parallelism.

 

LEARN MORE